TL;DR
Monoblocc is built on open, industry-standard interfaces: M12 mounting threads, 1/4"-20 accessory threads, 15 mm rods at 60 mm camera-rig spacing.
That means third-party camera-rig gear fits directly — and you can design and 3D-print your own attachments to the specs below.
Interface standards
Interface | Specification |
Rod / plate mounting points | M12 threads |
Rod clamps (front/side), cheese plates, Magic Arm ends | 1/4"-20 thread |
Rod clamps (top/bottom) | M12 threads |
Rod diameter / rail spacing | 15 mm rods, 60 mm spacing (camera-rig standard) - compatible with third-party 15 mm rig gear |
VESA support | 75×75 and 100×100 (M4 steel screws) |
Material / finish | Precision-CNC'd and annodized aluminum |
Fastener inventory (what the hardware is called)
35 mm M4 countersunk screws + thumb nuts - fasten the VESA plate to your monitor arm's head.
45 mm and 55 mm M4 studs - mount your monitor onto the plate; two lengths for flush vs recessed VESA.
5 mm and 10 mm spacers - pair with 55 mm studs for recessed VESA mounts.
2 mm Allen key - drives the M4 studs.
2.5 mm Allen key - drives the M4 countersunk screws.
M12 → 1/4"-20 adapters - male-to-male (Single Rod kits) and male-to-female Magic Arm kits
M12 end caps - cover unused rod ends on Double Rods
Load ratings
Our rods are made of milled aluminium and so strong that the practical limiting factor is your monitor arm's weight capacity (total load capacity and how much rotational force its VESA head can withstand). You can replace our tripod heads or magic arms with third party heavy dutry versions and mount pretty much any camera or light as long as your monitor arm can carry it. Please note heavy accessories mounted a great enough distance to the VESA plate may induce sway, similar to a pendulum. This is more significant the lighter your monitor itself is.
Single Rods: limited by tripod head and monitor arm strength
Double Rods: limited by tripod head and monitor arm strength
Tripod Heads: 2 lb / 1.0 kg
Magic Arm: 4.5 lb / 2.0 kg
Component weights: see "Weight limits: what can Monoblocc hold?"
Build your own attachments
Want to 3D-print a head-tracker mount, a stream-deck cradle, or something we haven't thought of? Design to the 1/4"-20 or M12 interfaces above and it will bolt on.
FAQs
Can I use third-party 15 mm rods and clamps?
Can I use third-party 15 mm rods and clamps?
Yes - anything following the 15 mm rod standard with M12-compatible threading and 60 mm spacing integrates directly.
What torque should the fasteners be tightened to?
What torque should the fasteners be tightened to?
Hand-tight with the supplied tools is sufficient
Will you sell individual components?
Will you sell individual components?
We currently only sell entire kits but you can substitute our components with third party mounting hardware such as m12 to 1/4"-20 connectors, 15mm rods, M4 steel screws, tripod heads and magic arms etc.